Important: Always maintain cleanliness when servicing fuel system components.

1. Relieve fuel system pressure. Refer to Fuel Pressure Relief .
2. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
3. Note strainer (3) position for future reference.



4. Support the reservoir with one hand and grasp the strainer with the other hand.
5. Use a screwdriver to pry the strainer ferrule off the reservoir.
6. Discard the strainer.

1. Install the new strainer (4) to the reservoir.
2. Support the reservoir with one hand and grasp the strainer with the other hand twisting the strainer into position.
3. Reinstall the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
5. Inspect the fuel system for leaks by performing the following steps:

5.1.	Turn the ignition switch ON position for 2 seconds.

5.2.	Turn the ignition switch OFF for 10 seconds.

5.3.	Turn the ignition switch ON.

5.4.	Inspect for fuel leaks.