- Do not expose the inflator modules to temperatures above 65°C
(150°F).
 
- Verify the correct replacement part number. Do not substitute
a component from a different vehicle.
 
- Do not repair any of the following components. Service these components
by replacement only:
 
| •  | The inflatable restraint sensing and diagnostic module (SDM) | 
 
| •  | The inflatable restraint IP module | 
 
| •  | The inflatable restraint steering wheel module | 
 
| •  | The inflatable restraint steering wheel module coil | 
 
| •  | The inflatable restraint side impact sensor (SIS) | 
 
| •  | The inflatable restraint driver seat module | 
 
- Use only original GM replacement parts available from your authorized
GM dealer. Do not use salvaged parts for repairs to the SIR system.
 
- Discard any of the following components if the component has been
dropped from a height of 91 cm (3  ft) or greater:
 
| •  | The inflatable restraint sensing and diagnostic module (SDM). | 
 
| •  | The inflatable restraint IP module. | 
 
| •  | The inflatable restraint steering wheel module. | 
 
| •  | The inflatable restraint steering wheel module coil. | 
 
| •  | The inflatable restraint side impact sensor (SIS) | 
 
| •  | The inflatable restraint driver seat module | 
 
- When you replace the SDM, verify that the following conditions
are met:
 
| •  | The mounting surface is clean. | 
 
| •  | The arrow on the module points toward the front of the vehicle. | 
 
| •  | The module is flat on the mounting surface, parallel to the vehicle
datum line. | 
 
| •  | The module fasteners are installed and tightened as specified. | 
 
- When you replace a side impact sensor (SIS), verify that the following
conditions are met:
 
| •  | The mounting surface is clean. | 
 
| •  | The module is flat on the mounting surface. | 
 
| •  | The module fasteners are installed and tightened as specified. | 
 
- In order to avoid setting false diagnostic trouble codes, only
apply power to the SIR system when one of the following two conditions is
met:
 
| •  | All SIR system components are properly mounted and electrically
connected. | 
 
| •  | A diagnostic procedure directs you to turn ON the ignition. |