Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Turn the ignition to OFF.
2. Disconnect wiper/washer switch connector C201.
3. Turn the wiper switch to DELAY.
4. Measure the resistance through the wiper/washer switch from connector C201, terminal E5 to terminal E2, using a J 39200 set to the ohms scale.
5. Move the wiper switch through the entire delay range, one notch at a time.

Does the resistance vary within the specified values?

37 Kohms to 714 Kohms

Go to Step 4

Go to Step 3

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

1. Reconnect the wiper/washer switch connector C201.
2. Disconnect the wiper motor connector.
3. Turn the ignition switch to RUN.
4. Turn the wiper switch to DELAY.
5. Measure the voltage from the wiper motor connector, terminal E, to ground using a J 39200 .

Is the voltage measured within the specified value?

10.5-15 V

Go to Step 6

Go to Step 5

Repair the poor connection or the open CKT 112.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor cover. Refer to Windshield Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--