Step
| Action
| Value(s)
| Yes
| No
|
1
|
Important: Inspect all of the keys for matching codes.
- Insert the ignition key into the J 35628-A
.
- Turn the J 35628-A
ON.
- Read the key code on the display of the J 35628-A
.
Is the key code a value of 1-15?
| 1-15
|
Go to Step 2
|
Go to Step 5
|
2
|
- Write down the key code that the J 35628-A
displayed.
- Turn the J 35628-A
OFF.
- Connect the J 35628-A
to the 2-way ignition switch lock cylinder harness connector at the
base of the steering column.
- Insert the ignition key into the ignition switch lock cylinder.
- Turn the J 35628-A
ON.
- Observe the display on the J 35628-A
.
Is the key code the same as the code recorded in step 1?
| --
|
Go to Step 3
|
Go to Step 6
|
3
| Using a test lamp, frontprobe the
2-way connector at the base of the steering column, between terminal B
(BCM side) and B+.
Does the test lamp light?
| --
|
Go to Step 4
|
Go to Step
7
|
4
|
- Test for an open in circuit 1073.
- Test for a short to B+ in circuit 1073.
- Test for a short to ground in circuit 1073.
- If circuit 1073 is OK, replace the BCM. Refer to
Body Control Module Replacement
.
Is the repair complete?
| --
| System OK
| --
|
5
|
- Clean the key.
- Retest the key. If the key code is invalid, replace the key. Refer
to
Body Control Module (BCM) Programming/RPO Configuration
.
Did you replace the key?
| --
| System OK
| --
|
6
|
Important: If you repair the lock cylinder harness, the SECURITY indicator will
remain ON for approximately 1 minute.
Inspect for a poor connection. If the connection is OK, replace the
ignition switch lock cylinder. Refer to
Ignition Switch Replacement - On Vehicle
floor
or
Ignition Switch Replacement - On Vehicle
colum .
Is the repair complete?
| --
| System OK
| --
|
7
|
- Disconnect the BCM.
- Connect a test lamp between the BCM connector C3 terminal C1
and B+.
Does the test lamp light?
| --
|
Go to Step 8
|
Go to Step
9
|
8
|
- Test for poor connections at BCM connector C3 terminal
C2 and terminal D7.
- Test for an open in circuit 1074.
- If all connections are OK, replace the BCM. Refer to
Body Control Module Replacement
.
Is the repair complete?
| --
| System OK
| --
|
9
| Repair the open in circuit in 650.
Is the repair complete?
| --
| System OK
| --
|
