Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you review
the operation and perform the necessary inspections?
| --
|
Go to Step 2
| Go to
Symptoms
|
2
|
- Use a test lamp in order to probe between B+ and the inoperative
door lock switch connector terminal A. Refer to
Circuit Testing
in Wiring Systems.
- Press the inoperative door lock switch to the lock position.
Does the test lamp illuminate?
| --
| Go to
Step
3
| Go to
Step
4
|
3
| Repair a poor connection or open
in circuit 195. Refer to
Wiring Repairs
or
Connector Repairs
in
Wiring Systems.
Is the repair complete?
| --
| Go to
Step
5
| --
|
4
| Replace the inoperative door lock switch. Refer to
Door Trim Plate Replacement
.
Is the repair complete?
| --
| Go to
Step
5
| --
|
5
|
- Turn the ignition switch to the LOCK position.
- Reinstall the connectors and components that were removed.
- Turn the ignition switch to the LOCK position.
- Remove the BCM PRGRM fuse.
- Turn the ignition switch to the ACC position. (The BCM sounds
the chime a number of times equivalent to the BCM type installed on the vehicle).
- Turn the ignition switch from the ACC position, to the LOCK position,
then back to the ACC position within 1 second. (The BCM sounds any
DTCs stored).
Are there any BCM DTCs present?
| --
| Go to
Diagnostic Trouble Code (DTC) List/Type
in Body
Control System
| Go to
Step 6
|
6
| Operate the system in order to verify the repair.
Did you correct the condition?
| --
| System OK
|
Go to Step
2
|
