Tools Required

1. Position the torque converter (1) on the bench with the flywheel lugs facing down.
2. Install J 26900-13 , J 35138 , and J 8001 onto the torque converter (1).
3. Set the dial indicator to 0.
4. Lift J 35138 and note the dial indicator reading:

•	The torque converter end play should be 0.5 mm (0.020 in) or less

•	If the end play is too high, replace the torque converter (1)




5. Inspect and replace the torque converter (1) for the following conditions:

•	Overheated (torque converter will be blue in color)

•	Leaking at the weld areas

•	A damaged torque converter pilot

•	Evidence of metal particles in the converter, the oil cooler, or the cooler pipes

•	A damaged torque converter stator, a damaged pump, or a damaged turbine

•	A damaged or worn torque converter bushing (2)

•	Contaminated automatic transmission fluid due to engine coolant

6. Inspect the torque converter for stripped bolt hole threads. If found, repair the torque converter.