For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0131 00: ABS Pressure CircuitCircuit/System Description
The electronic brake control module (EBCM) uses input from the brake pressure sensor for more accurate control during a vehicle stability enhancement system (VSES) event.
Conditions for Running the DTC
| • | Ignition ON. |
| • | Ignition voltage is greater than 8 volts. |
Conditions for Setting the DTC
| • | Brake signal does not correlate to pressure signal. |
| • | Signal is erratic and changes faster than physically allowed. |
Action Taken When the DTC Sets
| • | The Traction Control indicator illuminates. |
| • | The driver information center (DIC) displays Service Stability System. |
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
The brake fluid pressure sensor is integral to the BPMV/EBCM. The brake fluid pressure sensor is not serviceable.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Verify that DTC C0277, C0297, or B3445 is not set.
- Ignition ON, observe the scan tool BPP parameter while applying and releasing the brake pedal. The reading should change between Applied and Released.
| ⇒ | If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle. |
| ⇒ | If the parameter does not change between applied and release, replace the BPMV and verify DTC does not reset. If DTC reset, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for EBCM setup, replacement, and programming |
