Removal Procedure
- Remove the cross vehicle beam. Refer to
Instrument Panel Tie Bar Replacement
in Instrument Panel, Gauges and
Console.
- Remove the defroster door actuator. Refer to
Defroster Valve Actuator Replacement
in Manual HVAC Systems.
- Remove the mode door actuator. Refer to
Mode Actuator Replacement
in Manual HVAC Systems.
- Remove the defroster door link between the defroster door and
the vent door on the RH side of the HVAC control module.
- Remove the air distribution
case cover retaining screws (1).
- Remove the air distribution case cover (2).
- Remove the defroster door
(1).
Installation Procedure
Important: Align the defroster door assist spring to the HVAC control module case.
- Install the defroster door (1).
- Install the air distribution
case cover (2).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the air distributor cover retaining screws (1).
Tighten
Tighten the air distributor cover screws to 1.5 N·m (13 lb in).
- Install the defroster door link between the defroster door and
the vent door on the RH side of the HVAC control module.
- Install the defroster door actuator. Refer to
Defroster Valve Actuator Replacement
in Manual HVAC Systems.
- Install the mode door actuator. Refer to
Mode Actuator Replacement
in Manual HVAC Systems.
- Install the cross vehicle beam. Refer to
Instrument Panel Tie Bar Replacement
in Instrument Panel, Gauges and
Console.