The following is the proper procedure for the repair of
Weather Pack® Connectors.
| • | Separate the connector halves (1). |
| • | Open the secondary lock. A secondary lock aids in terminal retention
and is usually molded to the connector (1). |
| • | Grasp the wire and push the terminal to the forward most position.
Hold the wire in this position. |
| • | Insert the Weather Pack®
terminal removal tool into the front (mating end) of the connector cavity
until it rests on the cavity shoulder (1). |
| • | Gently pull on the wire to remove the terminal through the back
of the connector (2). |
| | Important: Never use force to remove a terminal from a connector.
|
| • | Reform the lock tang (2) and reset terminal in connector body. |
| • | Close secondary locks and join connector halves. |
| • | Verify that circuit is complete and working satisfactorily. |
