Tools Required

Important: 

•	The arrow located on top of the piston must point toward the front of the engine.

•	The connecting rod is non-directional and may be assembled/reassembled to the piston in either direction.

1. Lubricate the piston pin bores in the piston and the connecting rod with GM prelube lubricant GM P/N 1052367 (Canadian P/N 992869) or equivalent.
2. Assemble the piston and piston pin to the connecting rod. Properly orient the piston when reusing a marked connecting rod.
3. Align the piston pin bore with the connecting rod pin bore.
4. Slide the piston pin into the piston ad the connecting rod.




Important: New piston pin retainers must be used. Never reuse the piston pin retainers.

5. Install NEW piston pin retainers using the EN-46745 . Align the EN-46745 to the notch (1) in the piston.
6. Ensure that the piston pin retainers are fully seated in their grooves.
7. Repeat these procedures for the remaining pistons.

1. Properly orient the oil control ring expander as shown before installation. The ends of the expander must be facing toward the top of the piston.



2. Using a piston ring expander, install the oil control ring assembly using the following procedure:

2.1.	Install the expander ring (3).

2.2.	Install the 2 oil scraper rings (4). Expand the rings only enough to clear the piston diameter. Overexpanding the piston rings will distort or crack the rings.




3. Install the second and top piston rings using the ring expander. Ensure that you do not overexpand the rings.



4. Once the rings are installed, set the ring gaps for the oil control, second and top ring as follows. Use the piston location arrow for reference.

4.1.	Lower oil control ring - position 1.

4.2.	Upper oil control ring - position 2.

4.3.	Top Ring - position 3.

4.4.	Oil control ring expander - position 4.

4.5.	Second ring - position 5.

Important: If the connecting rod bearings have been used in a running engine, you must replace them with NEW connecting rod bearings for reassembly.

1. Clean the connecting rod and the connecting rod cap bearing bore with a lint-free cloth.
2. Clean all the oil from behind the connecting rod bearing halves.
3. Install new upper connecting rod bearings into position. Roll the bearing into position so that the lock tang engages the alignment slot. The bearing must fit flush in the connecting rod.
4. Install the EN 46121 into the connecting rod bolt holes.



5. Install new lower connecting rod bearings into position in the connecting rod cap. Roll the bearing into position so that the lock tang engages the alignment slot. The bearings must fit flush with the connecting rod cap.