1. Disconnect the battery. Refer to Battery Negative Cable Disconnection and Connection.
2. Remove front compartment sight shield Right side. Refer to Front Compartment Side Sight Shield Replacement

1

Underhood Electrical Center/Junction Block Cover Tab (Qty: 3)

Procedure

1. Push in on the 2 locking tabs located on the rear of the cover and lift in order to remove the cover.
2. Align the tabs on the cover with the corresponding locks on the electrical center.

2

Underhood Electrical Center/Junction Block Power Nut

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Disconnect the battery positive cable from the junction block by removing the nut.

Tighten
7 N·m (62 lb in)

3

Positive Cable to Junction Block Bolt (Qty: 2)

Tip
The bolts are part of the junction block. Do not try to remove.

Tighten
10 N·m (89 lb in)

4

Underhood Electrical Center/Junction Block Tab (Qty: 4)

Procedure

Remove the electrical center/junction block by using a hook-like tool to disengage the tabs.