For 1990-2009 cars only
Removal Procedure
- Loosen the fuel filler cap in order to relieve the system pressure.
- Disconnect the evaporative emission (EVAP) canister purge valve vacuum hose (1) from the engine vent adapter (2).
- Disconnect the electrical connector (2) from the coil pack (1).
- Disconnect the EVAP quick connect fitting. Refer to Plastic Collar Quick Connect Fitting Service .
- Remove the heated oxygen sensor connector (1) from the bracket (3).
- Disconnect the electrical connector (1) from the EVAP canister purge valve.
- Remove the bolt (6) securing the following to the crankcase vent housing (4):
- Remove the EVAP canister purge valve assembly from the engine.
| • | The heated oxygen sensor connector bracket (5) |
| • | The EVAP canister purge valve bracket (1) |
Important: Note the vacuum source hose routing.
Installation Procedure
- Position the EVAP canister purge valve assembly behind the intake plenum as previously noted during disassembly.
- Install the bolt (6) securing the following to the crankcase vent housing (4):
- Connect the electrical connector (1) to the EVAP canister purge valve.
- Install the heated oxygen sensor connector (1) to the bracket (3).
- Connect the EVAP quick connect fitting. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the electrical connector (2) to the coil pack (1).
- Connect the EVAP canister purge valve vacuum hose (1) to the engine vent adapter (2).
- Tighten the fuel filler cap.
Notice: Refer to Fastener Notice in the Preface section.
| • | The heated oxygen sensor connector bracket (5) |
| • | The EVAP canister purge valve bracket (1) |
Tighten
Tighten the EVAP canister purge valve bracket bolt to 8 N·m (71 lb in).
