Step
| Action
| Value(s)
| Yes
| No
|
DEFINITION:
LH or RH front side door lock switch lamp is inoperative.
|
1
| Was the
Interior Lights System Check performed?
| --
|
Go to Step
2
| Go to
Interior Lamps System Check
.
|
2
|
- Turn the ignition to the ON position.
- Determine which front side door lock switch lamp is inoperative.
Is the LH front side door lock switch lamp inoperative?
| --
|
Go to Step 8
|
Go to Step 3
|
3
|
- Disconnect the RH front side door lock switch connector.
- Turn the ignition switch to the ON position.
- Use the DMM to measure the voltage between terminal 3 of the RH
front side door lock switch connector and a known good ground.
Is the measured voltage within the specified value?
| B+
|
Go to Step 5
|
Go to Step
4
|
4
|
- Locate an open or a high resistance in circuit AP807.
- Repair the open or the high resistance in circuit AP807.
Is the repair complete?
| --
|
Go to Step
13
| --
|
5
| Use the DMM to measure the resistance between terminal 4 of the RH front
side door lock switch connector and a known good ground.
Is the measured resistance within the specified value?
| Less than 5 ohms
|
Go to Step 7
|
Go to Step 6
|
6
|
- Locate an open or a high resistance in circuit F12.
- Repair the open or the high resistance in circuit F12.
Is the repair complete?
| --
|
Go to Step
13
| --
|
7
| Replace the RH front side door lock switch. Refer to
Door Lock Switch Replacement
in Doors.
Is the replacement complete?
| --
|
Go to Step
13
| --
|
8
|
- Disconnect the LH front side door lock switch connector.
- Turn the ignition switch to the ON position.
- Use the DMM to measure the voltage between terminal 3 of the LH
front side door lock switch connector and a known good ground.
Is the measured voltage within the specified value?
| B+
|
Go to Step 10
|
Go to Step
9
|
9
|
- Locate an open or a high resistance in circuit AP807.
- Repair the open or the high resistance in circuit AP807.
Is the repair complete?
| --
|
Go to Step
13
| --
|
10
| Use the DMM to measure the resistance between terminal 4 of the LH front
side door lock switch connector and a known good ground.
Is the measured resistance within the specified value?
| Less than 5 ohms
|
Go to Step 12
|
Go to Step 11
|
11
|
- Locate an open or a high resistance in circuit F12.
- Repair the open or the high resistance in circuit F12.
Is the repair complete?
| --
|
Go to Step
13
| --
|
12
| Replace the LH front side door lock switch. Refer to
Door Lock Switch Replacement
in Doors.
Is the replacement complete?
| --
|
Go to Step
13
| --
|
13
|
- Connect all connectors and components that were disconnected.
- Verify that the LH and RH front side door lock switch lamps operate
properly.
Do the LH and RH front side door lock switch lamps operate properly?
| --
| Go to
Interior Lamps System Check
.
|
Go to Step 1
|
