GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2000 🢒 Catera 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Ignition Lock Cylinder Replacement - On Vehicle

Removal Procedure

    Object Number: 210357 Size: SH
  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Remove the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  3. Remove the steering wheel. Refer to Steering Wheel Replacement .
  4. Remove the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
  5. Remove the screw caps from the upper steering column cover.
  6. Remove the screws from the upper steering column cover.
  7. Remove the upper steering column cover.

    8. Object Number: 210364 Size: SH
  8. Remove the screws from the lower steering column cover.
  9. Remove the lower steering column cover.
  10. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
  11. Remove the turn signal switch. Refer to Turn Signal Switch Replacement - On Vehicle .

    12. Object Number: 210369 Size: SH
  12. Insert a small pointed awl or wire into the ignition lock cylinder release pin hole.
  13. Pull out the ignition lock cylinder.

Installation Procedure

    Object Number: 210472 Size: SH
  1. Install the lock cylinder:
    2. • Look into the hole that receives the ignition lock cylinder on the lower RH side in order to locate the locking lever.
    • Carefully push down on the locking lever using a small flat-bladed tool untill an audible click is heard.
    • Install the ignition lock cylinder.
  2. Install the turn signal switch. Refer to Turn Signal Switch Replacement - On Vehicle .

    3. Object Number: 210364 Size: SH
  3. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
  4. Install the lower steering column cover.
  5. Install the screws to the lower steering column cover.

    6. Object Number: 210357 Size: SH
  6. Install the upper steering column cover.
  7. Install the screws to the upper steering column cover.
  8. Install the screw caps to the upper steering column cover.
  9. Install the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
  10. Install the steering wheel. Refer to Steering Wheel Replacement .
  11. Install the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  12. Enable the SIR system. Refer to Enabling the SIR System in SIR.