For 1990-2009 cars only
- With the water crossover on the bench, install all eight crossover bolts in locations as shown.
- Slide the upper and lower water crossover gaskets onto the bolts with the crossover still on the bench.
- Place the water crossover in position and hand start the bolts to hold the crossover in place.
- Tighten the water crossover bolts in sequence (1-8) and tighten to 25 N·m (18 lb ft).
- Place the water pump drive belt tensioner in position on the water pump housing.
- Install the water pump drive belt tensioner bolts and tighten to 10 N·m (89 lb in).
- Feed the water pump drive belt around the water pump pulley and the water pump drive belt tensioner.
- Compress the drive belt tensioner. Feed the drive belt around the drive pulley.
- Check the drive belt for proper seating in all the pulley grooves.
- Place the water pump drive belt shield in position.
- Hand start the water pump drive belt shield nuts on the studs.
- Hand start the water pump drive belt shield bolt.
- Tighten the water pump shield nuts and bolt.
| • | Bolt (1) length 40.7 mm (1.6024 in) |
| • | Bolts (2) length 92.0 mm (3.6220 in) |
| • | Bolts (3) length 109.0 mm (4.2913 in) |
| • | Bolts (4) length 115.0 mm (4.5276 in) |
Caution: Refer to Fastener Caution in the Preface section.
| 13.1. | Tighten the water pump shield nuts to 10 N·m (89 lb in). |
| 13.2. | Tighten the water pump shield bolt to 10 N·m (89 lb in). |
