Removal Procedure
- Remove the lower controls assembly. Refer to
Lower Controls
.
- Remove the final drive assembly and parking gear. Refer to
Final Drive Assembly Replacement
- Move the manual shaft from the park position.
- Drive out the parking pawl pivot pin using
a pin punch. Push down on the spring while driving the pin out.
- Remove the parking pawl and the spring.
- Inspect the following:
| • | Parking pawl tooth for damage |
| • | Parking pawl spring for over expansion |
| • | Pivot pin for scorning, excessive wear |
Installation Procedure
- Place the pawl in the case slot. Attach
the spring to the pawl.
- Insert the pivot pin through the spring
and pawl. The hook end of the spring locates on the case and the square end
on top of the parking pawl.
- Install the pivot pin using a mallet.
- Install the final drive assembly. Refer to
Final Drive Assembly Replacement
.
- Install the lower controls assembly and the bottom pan. Refer
to
Lower Controls
.
