Important: Ensure that the adjustable accelerator pedal
and adjustable brake pedal are synchronized in the full forward, front of vehicle
position.
Important: During the synchronization procedure, do
not exceed 0.5 N·m (4.43 lb in) of torque while adjusting
the pedals with the use of the cable, or the square drive.
- Synchronize the pedals to the full forward position.
- Synchronize the brake pedal to the full
forward position. Use the instrument panel switch, the Tech II, or manually move the
brake pedal as follows:
| 2.1. | Use an adjustable wrench on the accelerator pedal end of the accelerator
pedal cable (1). |
| 2.2. | Slowly rotate the accelerator cable to move the brake pedal to the full
forward, front of vehicle position. |
| 2.3. | Remove the wrench from the vehicle. |
- The new accelerator pedal assembly should already be synchronized to the
full forward position. If the pedal is not synchronized, proceed as follows before
installation:
| 3.1. | Install a square drive tool into the accelerator pedal where the cable
attaches. |
| 3.2. | Carefully rotate the tool to move the adjustable pedal to the full forward
position. |
| 3.3. | Remove the square drive tool. |
- Connect the adjustable accelerator pedal cable (1) to the pedal
assembly.
- Ensure that the adjustable accelerator pedal cable retaining feature is
locked in place by carefully pulling on the cable.
- Connect the electrical connector to the linear position sensor.
- Connect the electrical connector to the
electronic throttle control sensor (3).
- Install the accelerator pedal assembly to the mounting studs.
Notice: Refer to Fastener Notice in the Preface section.
- Install the accelerator pedal assembly mounting nuts (4).
Tighten
Tighten the accelerator pedal assembly mounting
nuts to 9 N·m (80 lb in).
- Install the knee bolster bracket. Refer to
Driver Knee Bolster Bracket Replacement
in Instrument Panel, Gages, and
Console.
- Perform the adjustable pedal calibration procedure. Refer to
Adjustable Pedal System Calibration
.
