GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 SRX 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Ignition Lock Cylinder Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 803004 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Turn the ignition switch to the START position.
  3. Insert the awl into the lower steering column trim cover access hole.
  4. Press in the release button using the awl.

    5. Object Number: 803003 Size: SH
  5. Release the ignition switch to the RUN position.
  6. Remove the ignition lock cylinder.

Installation Procedure

    Object Number: 803003 Size: SH
  1. Install the ignition lock cylinder by doing the following procedure:
    2. • Align the positioning locking tab slot on the lock module to the positioning tab on the ignition lock cylinder.
    • Push the lock cylinder in until the locking tab locks in the lock module.
  2. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.