Step | Action | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Wiper/Washer Connector End Views | |||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||||
2 | Verify that the moisture sensing inoperative fault is present. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||||
3 | While the windshield wiper/washer system is in the automatic mode does the wiper motor operate at normal delay intervals? | Go to Step 5 | Go to Step 4 | ||||||
4 |
Does the wiper motor cycle once and stop every time the switch is advanced to the next delay position? | Go to Step 5 | -- | ||||||
5 |
Does the test lamp illuminate? | Go to Step 6 | Go to Step 10 | ||||||
6 | Connect a test lamp between the accessory voltage circuit of the moisture sensor connector and the ground circuit of the moisture sensor connector. Does the test lamp illuminate? | Go to Step 7 | Go to Step 11 | ||||||
7 | Test the outside moisture sensor signal 1 circuit for the following conditions:
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 13 | Go to Step 8 | ||||||
8 | Test the outside moisture sensor signal 2 circuit for the following conditions:
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 13 | Go to Step 9 | ||||||
9 | Inspect for poor connections at the harness connector of the outside moisture sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 13 | Go to Step 12 | ||||||
10 | Repair the short to ground or open in the accessory voltage circuit of the outside moisture sensor. Refer to Circuit Testing and Wiring Repairs . Is the repair complete? | Go to Step 13 | -- | ||||||
11 | Repair the high resistance or open in the ground circuit of the outside moisture sensor. Refer to Circuit Testing and Wiring Repairs . Is the repair complete? | Go to Step 13 | -- | ||||||
12 | Replace the outside moisture sensor. Did you complete the replacement? | Go to Step 13 | -- | ||||||
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 | ||||||
