| Table 1: | Vehicle Direction Alert Alarm Warning Module Scan Tool Data Parameters |
| Table 2: | Vehicle Direction Alert Alarm Warning Module Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
|---|---|---|---|
Operating Conditions: Ignition ON | |||
Battery Voltage | -- | Varies | This displays Volts. This is the current battery voltage signal. |
Calibration Status | -- | Normal | The scan tool displays OK or Inhibit. |
Calibration Status | -- | Complete | The scan tool displays Inactive, Complete or In Progress. This is the current calibration status of the module. |
Diagnostic Mode | -- | Normal | The scan tool displays OK or Inhibit. |
Operating State | -- | Ready | The scan tool displays Off, Disabled, Not Ready or Ready. This is the current operating state of the module. |
Power Mode | -- | OK | The scan tool displays OK or Inhibit. |
Power Mode | -- | Run | The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch. |
Reference Voltage 1 | -- | Varies | This displays Volts. This is the current reference voltage 1. |
Reference Voltage 2 | -- | Varies | This displays Volts. This is the current reference voltage 2. |
Serial Data | -- | Normal | The scan tool displays OK or Inhibit. |
System Operation Status | -- | Normal | The scan tool displays Unknown, Normal, Disabled or Failed. |
System Power Mode | -- | OK | The scan tool displays OK or Inhibit. |
Output Control | Description |
|---|---|
Calibrate Module | This output control is used to calibrate the module. |
Direction Warning Left | This output control is used to command the left direction warning. |
Direction Warning Right | This output control is used to command the right direction warning. |
