Removal Procedure
- Press in on the long sides
of the lens.
 
- Remove the lens.
 
- Remove the bulb.
 
- Gently pry off the housing.
 
- Disconnect the electrical connectors.
 
- Squeeze the clip tangs together at each clip and push the clip
connector up through the housing.
 
Installation Procedure
- Connect the electrical
connectors to the housing.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the housing to the roof inner trim panel with 2 screws.
 
Tighten
Tighten the dome lamp housing screws to 2 N·m (18 lb in).
- Install the bulb.
 
- Install the lens.