Did you perform the Exterior Lights System Check?

--

Go to Step 2

Go to Exterior Lights System Check

1. Disconnect the trailer tow wiring to the trailer, if equipped.
2. Ensure that the trailer tow wiring does not cause the stop lamps to remain ON.
3. Disconnect the Brake Pedal Position switch.

Do all of the stop lamps remain ON?

--

Go to Step 3

Go to Step 4

Disconnect the turn/hazard switch connector (part of C201).

Does the center high mounted stop lamp remain ON?

--

Go to Step 5

Go to Step 6

Replace the Brake Pedal Position switch. Refer to Stop Lamp Switch Replacement in Hydaulic Brakes.

Is the repair complete?

--

Go to Exterior Lights System Check

--

Repair the short to voltage in CKT 17 (WHT) between the following components:

Is the repair complete?

--

Go to Exterior Lights System Check

--

Inspect the other stop lamps with the turn/hazard switch connector (part of C201) still disconnected.

Does the left side stop lamp remain ON?

--

Go to Step 7

Go to Step 8

Repair the short to voltage in CKT 18 (YEL) between the following components:

Is the repair complete?

--

Go to Exterior Lights System Check

--

Inspect the other stop lamps with the turn/hazard switch connector (part of C201) still disconnected.

Does the right side stop lamp remain ON?

--

Go to Step 9

Go to Step 10

Repair the short to voltage in CKT 19 (DK GRN) between the following components:

Is the repair complete?

--

Go to Exterior Lights System Check

--

Inspect all of the stop/lamps with the turn/hazard switch connector (part of C201) still disconnected.

Do any of the stop lamps remain on?

--

Go to Step 2

Go to Step 11

Replace the turn/hazard switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Sterring.

Is the replacement complete?

--

Go to Exterior Lights System Check

--