| Table 1: | Chucking Over Bumps | 
| Table 2: | Itching Noise | 
| Table 3: | Inner Door Panel Rattles | 
| Table 4: | Rattle Noise at the Rear Latch | 
| Table 5: | Itch Noise at the Bottom of the Door | 
| Table 6: | Rattle Around Window | 
| Table 7: | Swing Out Window Latch Rattles | 
| Table 8: | Itch Noise in Window Area | 
Problem  | Action  | 
|---|---|
The locators are misaligned.  | 
  | 
The lower roller is misaligned.  | Adjust the lower roller.  | 
Problem  | Action  | 
|---|---|
The door lock pillar molding rubs on the door trim panel.  | Apply low friction tape (GM P/N 22586239 or equivalent) to the door lock pillar molding.  | 
Problem  | Action  | 
|---|---|
The inner door panel is flexing.  | Shim the inner and the outer door panels with foam tape in the center of the door.  | 
Problem  | Action  | 
|---|---|
There are too many/few washers in the rear striker.  | 
  | 
Problem  | Action  | 
|---|---|
The trim panel hits on the stepwell pad.  | Remove the lip from the stepwell with a knife.  | 
Problem  | Action  | 
|---|---|
The rear edge of the garnish molding rattles.  | Insulate the inside of the garnish molding with foam tape.  | 
Problem  | Action  | 
|---|---|
There is improper coating on the pin.  | Install a teflon pin (GM P/N 15690675 or equivalent).  | 
Problem  | Action  | 
|---|---|
The window contacts the trim panel.  | 
  |