Stop Lamps Inoperative Domestic
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Is the CHMSL also inoperative? | -- | Go to Step 3 | Go to Step 8 |
3 |
Does the test lamp light? | Go to Step 4 | Go to Step 5 | |
4 | Connect a fused jumper from CKT 17 (WHT) cavity A to CKT 140 (ORN) cavity B of the brake pedal position switch. Do the stop lamps light? | -- | Go to Step 6 | Go to Step 7 |
5 | Repair the open in CKT 140 (ORN) between the brake pedal position switch and splice S221 Is the repair complete? | -- | Go to Step 11 | -- |
6 | Replace the brake pedal position switch. Refer to Stop Lamp Switch Replacement in Hydraulic Brakes. Is the repair complete? | -- | Go to Step 11 | -- |
7 | Repair the open in CKT 17 (WHT) between the brake pedal position switch and the CHMSL assembly. Is the repair complete? | -- | Go to Step 11 | -- |
8 | Using a test light, backprobe CKT 17 (WHT) convertor C201 cavity A1 at the turn/hazard switch (to ground). Does the test lamp light? | -- | Go to Step 10 | Go to Step 9 |
9 | Repair the open in CKT 17 (WHT) between turn/hazard switch connector C201 and the CHMSL assembly. Is the repair complete? | -- | Go to Step 11 | -- |
10 | Replace the turn/hazard switch Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle Is the repair complete? | -- | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
Stop Lamps Inoperative VE1
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the test lamp light? | -- | Go to Step 3 | Go to Step 4 |
3 | Connect a fused jumper from CKT 17 (WHT) cavity A to CKT 140 (ORN) cavity B of the Brake Pedal Position switch. Do the stop lamps light? | -- | Go to Step 5 | Go to Step 6 |
4 | Repair the open in CKT 140 (ORN) between the Brake Pedal Position switch and S221. Is the repair complete? | -- | Go to Step 7 | -- |
5 | Replace the Brake Pedal Position switch. Refer to Stop Lamp Switch Replacement Stoplamp Switch Replacement in Hydraulic Brakes. Is the replacement complete? | -- | Go to Step 7 | -- |
6 | Repair the open in CKT 17 (WHT) between the Brake Pedal Position switch and S400. Is the repair complete? | -- | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
