Disassembly Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
| • | Unnecessary SIR system repairs |
| • | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
| • | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable restraint steering
wheel module. Refer to
Disabling the SIR System
in SIR.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers - Disassemble - Off Vehicle
.
- Remove the wire harness assembly (4) out of the wire harness
strap (5).
Remove the wire harness straps (3) from the wire harness assembly (4).
Remove the wire harness strap (2) from the upper tilt head assembly (1).
- Slide the 2 connectors (2)
off from the bulk head connector (1).
- Remove the key alarm connector (1)
from the electronic lock module assembly (2).
- Remove the 2 tapping screws from the ignition and key alarm
switch assembly (3).
- Remove the ignition and key alarm switch assembly (3).
