Tools Required
| • | J 43911 Selector Shaft
Seal Remover |
| • | J 43909 Selector Shaft
Seal Installer |
Removal Procedure
- Remove
the park/neutral position (PNP) switch. Refer to
Park/Neutral Position Switch Replacement
.
- Ensure that the jackscrew for J 43911
is backed off and will not interfere with installation of the removal
tool. Slide the seal remover tool over the selector shaft (2) with the threaded end
of the tool towards the seal.
- Rotate the removal tool so that the threads on the end of the tool engage
the steel shell (1) of the seal. Use a wrench to ensure that the removal tool is firmly
attached to the seal shell.
- Rotate the jackscrew in the clockwise direction to remove the seal from
the bore. Discard the seal that was removed.
Installation Procedure
- Carefully
slide a new selector shaft seal (1) over the selector shaft (2) with the wide face
of the steel case facing outward. Position the seal so that it is starting to enter
the seal bore.
- Obtain J 43909
and
remove the inner sleeve so that the tool will slide over the selector shaft.
- Slide the J 43909
into
position so that the end of the tool contacts the seal being installed. Use a mallet
to strike the J 43909
and drive
the new seal into the bore until it is seated at the bottom of the bore.
- Install the PNP switch. Refer to
Park/Neutral Position Switch Replacement
.
- Fill the transmission to the proper level with DEXRON® III transmission
fluid. Refer to
Transmission Fluid Check
.
