Sunroof Window Replacement CF5

Important: The sunroof must be in the fully closed position prior to removing the glass panel.

1. Open the sunshade panel.



2. Remove the 4 screws (2) that retain the sunroof window (1) to the sunroof module assembly.
3. Remove the sunroof window from the top of the vehicle.

1. Position the sunroof window (1) to the vehicle.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the screws (2) that retain the sunroof window (1) to the sunroof module assembly.
3. Perform the following steps in order to adjust the sunroof window.

3.1.	Adjust the fit between the sunroof window and the roof opening.

The fit should be equal on both sides.

3.2.	Adjust the rear edge of the window slightly higher than the front edge in order to minimize wind noise.

Tighten
Tighten the sunroof window screws to 3 N·m (27 lb in).

4. Open and close the sunroof.
5. Inspect the fit of the sunroof window.

Sunroof Window Replacement ZRX/XTREME w/ CF5

1. Remove the window panel garnish molding (1). Refer to Sunroof Panel/Window Garnish Molding Replacement in Interior Trim.



2. Remove the 2 front screws (2) that retain the sunroof window to the sunroof slider arm.



3. Remove the 2 rear screws (2) that retain the sunroof window (1) to the sunroof slider arm.



4. With the palm of the hand, remove the sunroof window from the top of the slider arms.

1. With the palm of the hand, position the sunroof window to the slider arm.

Important: The sunroof window is self locating to the slider arm.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the 4 sunroof window screws (2).

Tighten
Tighten the sunroof window screws to 4 N·m (35 lb in).

3. Close the sunroof window.
4. Inspect the fit of the sunroof window to the outer periphery of the sunroof panel window seal.



5. Install the interior window panel garnish molding (1). Refer to Sunroof Panel/Window Garnish Molding Replacement in Interior Trim.
6. Clean the sunroof window.