GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Blazer - 4WD 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Latch Control Handle Replacement

Removal Procedure

    Object Number: 870151 Size: SH
  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement
  2. Release both lock rods from the lock rod retainers (1) on the handle.
  3. Remove the bolts retaining the latch control handle to the door.
  4. Remove the latch control handle from the door.

Installation Procedure

    Object Number: 870151 Size: SH
  1. Install the latch control handle to the door.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the bolts retaining the latch control handle to the door.

    3. Tighten
    Tighten the bolts to 8 N·m (71 lb in).

  3. Position the upper lock rod in the retainer (1) so that there is 10 1-2 mm (0.39-0.47 in). (Approximately 11-12 threads showing) from the end of the lock rod.
  4. Position the lower latch rod in the retainer where it rests, usually 5-6 mm (0.19-0.23 in) of threads showing from the end of the latch rod.
  5. Check for proper door operation.
  6. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .