Important: A short to ground will cause an open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open.

Did you perform the Headlamp DRL System Check?

--

Go to Step 2

Go to Daytime Running Lights (DRL) System Check

1. Disconnect the turn/hazard headlamp switch assembly connector C1.
2. Use a fused jumper in order to ground terminal C to E of the turn/headlamp hazard switch Connector C1.

Do the headlamps operate properly?

--

Go to Step 4

Go to Step 3

Locate and repair an open or bad connection in CKT 350 between the turn/hazard headlamp switch assembly and ground. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--

Replace the turn/hazard headlamp switch assembly.

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--