For 1990-2009 cars only
Tail Lamp/Brake Lamp Inoperative (Replace Bulb and Socket)
| Subject: | Tail Lamp/Brake Lamp Inoperative (Replace Bulb and Socket) |
| Models: | 2003 Chevrolet Cavalier |
| 2003 Pontiac Sunfire |
This bulletin is being revised to provide the latest parts information. Please discard Corporate Bulletin Number 04-08-42-004 (Section 08- Body & Accessories).
Condition
Some customers may comment that the left or right tail lamp, brake lamp or turn signal is inoperative.
Cause
This condition may be caused by a loose fitting bulb in the socket. This higher resistance may cause the bulb to burn out and damage the socket.
Correction
| • | Inspect the socket terminal to make sure it is tight against the bulb. Use a small pick to adjust the terminal if needed. |
| • | After inspecting the socket, it may be necessary to replace it with the bulb. |
| • | Apply dielectric lubricant or dielectric grease to the socket before installing the bulb. |
| • | After the repair is completed, inspect the other lamp and apply dielectric lubricant or dielectric grease to the socket. |
| Important: If it was necessary to replace the socket, repeat the steps above. |
Parts Information
Part Number | Description |
|---|---|
9441839 | Bulb |
16522273 | Socket-Tail Lamp/Brake Lamp With rear Side Marker |
16519904 | Socket- Tail Lamp/Brake Lamp With Out Rear Side Marker |
Parts are currently available from GMSPO.
Warranty Information
For vehicle repaired under warranty, use;
Labor Operation | Description | Labor Time |
|---|---|---|
N0912 | Socket, Lamp Exterior- Replace | Use Published Labor Operation Time |
