Wipers Delay Mode Inoperative Rear
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION : Use this diagnostic table only if the rear wipers operate in the standard operating mode. | ||||
1 | Did you perform the Rear Wiper/Washer System Check? | -- | Go to Step 2 | |
2 |
Did the test lamp light? | -- | Go to Step 3 | Go to Step 4 |
3 |
Did the test lamp light? | -- | Go to Step 5 | Go to Step 6 |
4 | Replace the rear window wiper/washer switch. Is the repair complete? | -- | -- | |
5 | Replace the rear window wiper/washer module. Refer to Rear Window Wiper Motor Replacement . Is the repair complete? | -- | -- | |
6 | Repair the open in CKT 391 (GRY) between the rear window wiper/washer module and the rear window wiper/washer switch. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | -- | |
Wipers Delay Mode Inoperative Front
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Front Wipers/Washers System Check? | -- | Go to Step 2 | |
2 |
Is the resistance near or equal to the specified value? | 680 ohms | Go to Step 3 | Go to Step 5 |
3 | With DMM still connected, move the windshield wiper/washer switch through the delay range to the maximum delay position while observing the meter. Do the readings increase in steps to the approximate value? | 450 k ohms | Go to Step 4 | Go to Step 5 |
4 |
Is the repair complete? | -- | -- | |
5 | Replace the windshield wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle . Is the repair complete? | -- | -- |
