- Remove the key from the ignition switch.
 
- Connect the passenger
yellow 2-way connector
(1) located behind the glove box.
 
- Install the connector position assurance (CPA) (2) to the passenger
yellow 2-way connector located behind the glove box.
 
- Connect the driver yellow
2-way connector (2) located at the base of the steering  column.
 
- Install the connector position assurance (CPA) (1) to the driver
yellow 2-way connector located at the base of the steering column.
 
- Install the AIR BAG Fuse to the IP fuse block.
 
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
 
| 7.1.  | The AIR BAG warning lamp will flash 7 times. | 
 
| 7.2.  | The AIR BAG warning lamp will then turn OFF. | 
 
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described.