1. Turn the ignition to the ON position.
2. Turn the turn signal ON.

Do the turn signals function properly?

--

Go to Step 2

Go to Turn Signal Lamps Inoperative

1. Turn the turn signal off.
2. Turn the ignition OFF.
3. Remove and inspect the HAZ LP fuse.

Is the fuse open?

--

Go to Step 8

Go to Step 3

1. Re-install the fuse.
2. Connect a test lamp (back probe) from terminal A4 of C201A to ground.

Does the test lamp light?

--

Go to Step 5

Go to Step 4

Locate and repair the open in CKT 140 (ORN) between the underhood bussed electrical center (UBEC) and C201A.

Is the repair complete?

--

System OK

--

1. Turn the hazard lights ON.
2. Connect a test lamp (back probe) from terminal E1 of C201C to ground.

Does the test lamp light?

--

Go to Step 7

Go to Step 6

Replace the turn/hazard switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Is the repair complete?

--

System OK

--

Locate and repair the open in CKT 1508 (LT BLU) between the turn/hazard switch and the turn/hazard flasher.

If no open is found, replace the turn/hazard flasher.

Is the repair complete?

--

System OK

--

Locate and repair the short to ground in CKT 1508 (LT BLU) or CKT 140 (ORN).

Is the repair complete?

--

System OK

--