Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | ||
2 |
Is the test light on? | -- | ||
3 | Connect a test light (backprobe) from terminal E5 at the wiper/washer switch connector C201C to ground. Is the test light on? | -- | ||
4 | Repair the open in CKT 112 between the switch and the motor. Is the repair complete? | -- | -- | |
5 | Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle . Is the replacement complete? | -- | -- | |
6 | Measure the voltage from terminal D to ground at the windshield wiper motor connector using a DMM. Is the voltage within the specified value? | 10.5-15 V | ||
7 | Replace the windshield wiper motor. Refer to Windshield Wiper Motor Replacement . Is the replacement complete? | -- | -- | |
8 | Measure the voltage from terminal E8 to ground at the wiper/washer switch connector C201C using a DMM. Is the voltage within the specified value? | 10.5-15 V | ||
9 | Repair the open in CKT 113 between the switch and the motor. Is the repair complete? | -- | -- |
