Step
| Action
| Value(s)
| Yes
| No
|
|
Important:
| • | Inspect the condition of the following fuses: |
| • | If you find any open fuse, locate and repair the source of the
overload. |
| • | Inspect for any set vehicle DTCs. Refer to the appropriate DTC
list from the following list: |
| • | Verify that ground G103 is clean and tight. |
| • | Inspect the cruise control linkage for loose, binding or improper
adjustment. |
|
1
|
- Disconnect the cruise control module.
- Turn the ignition switch to the RUN position.
- Turn the cruise control switch ON.
- Use a test lamp in order to front probe the cruise control module
connector between terminal C and ground.
- While observing test light, press and hold the R/A switch.
Does the test lamp light?
| --
|
Go to Step
2
|
Go to Step
5
|
2
|
| • | Inspect for a short to ground in CKT 87. |
| • | Inspect for a poor connection at the cruise control module terminal
C. |
Did you find a short to ground or a poor connection?
| --
|
Go to Step 3
|
Go to Step 4
|
3
|
| • | Repair the short to ground in CKT 87. |
| • | Repair the poor connection at the cruise control module terminal
C. |
Is the repair complete?
| --
| System OK
| --
|
4
| Replace the cruise control module. Refer to
Cruise Control Module Replacement
.
| --
| System OK
| --
|
5
| Inspect
CKT 87 for a poor connection or an open.
Did you find a poor connection or an open?
| --
|
Go to Step 6
|
Go to Step 7
|
6
| Repair the poor
connection or the open in CKT 87.
Is the repair complete?
| --
| System OK
| --
|
7
| Replace the multifunction lever. Refer to
Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle
Is the repair complete?
| --
| System OK
| --
|
