- Remove the key from the ignition switch.
- Connect the passenger yellow 2-way connector (1)
located near the base of the steering column.
- Install the Connector Position Assurance (CPA) (2) to the
passenger yellow 2-way connector located near the base of the steering column.
- Connect the driver yellow 2-way connector (2)
located at the base of the steering column.
- Install the Connector Position Assurance (CPA) (1) to the
driver yellow 2-way connector located at the base of the steering column.
- Install the AIR BAG Fuse to the IP fuse block.
- Staying well away from the air bags, turn ON the ignition.
| 7.1. | The AIR BAG warning lamp will flash 7 times. |
| 7.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the Diagnostic System Check - SIR if the AIR
BAG warning lamp does not operate as described. Refer to
Diagnostic System Check - SIR
.
