Circuit Description
This is an internal Fault in the Vehicle Interface Module (VIU).
Conditions for Running the DTC
The VIU will run this internal test at the beginning of every wake-up cycle. Battery voltage is at least 9.5 volts and no more then 15.5 volts.
Conditions for Setting the DTC
VIU fails the EEPROM test.
Action Taken When the DTC Sets
The customer may complain of loss of OnStar® functionality since the VIU will use ROM as a default.
Conditions for Clearing the MIL/DTC
VIU successfully completes the EEPROM tests.
Diagnostic Aids
If B1009 sets intermittently, check that battery positive voltage and ground for poor connections.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the OnStar® Diagnostic System Check? | -- | Go to Step 2 | Go to OnStar System Check |
2 |
Important: Perform the set up procedure for the VIU. Replace the VIU. Refer to Vehicle Interface Unit and Vehicle Communication Unit Modules Replacement . Did you complete the replacement? | -- | System OK | -- |
