Removal Procedure
- Remove the power accessory
 switch panel. Refer to 
Power Accessory Switch Panel Replacement 
.
 
- Disconnect the power window switch electrical connector.
 
- Remove the screws from the window switch.
 
- Remove the switch from the switch panel by lifting the rear of
 the switch and sliding the switch out from the switch panel.
 
Installation Procedure
- Install the switch to the switch panel sliding the front tabs
 in first. Rock the switch down in order to seat the switch completely.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the screws to the window switch.
 
Tighten
Tighten the window switch screws to 2 N·m (18 lb in).
- Connect the electrical connector to the window switch.
 
- Install the power accessory
 switch panel. Refer to 
Power Accessory Switch Panel Replacement 
.