For 1990-2009 cars only
Circuit Description
A replacement electronic brake control module (EBCM) is supplied with generic software and must be programmed to match the specific vehicle application.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0558 Calibration Data Not Programmed
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM is not programmed with complete software.
Action Taken When the DTC Sets
| • | The EBCM disables the ABS/DRP/TCS/VSES. |
| • | The ABS indicator turns ON. |
| • | The brake warning indicator turns ON. |
| • | The message center displays the service stability system message. |
| • | The traction off indicator turns on. |
Conditions for clearing the DTC
The DTC clears when software programming is complete.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Perform the set-up procedure for the EBCM. Refer to Service Programming System (SPS) in Programming. Did you complete the action? | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information | -- |
