Tools Required

Important: The balance shaft and the front bearing are serviced only as a package. Do not remove the bearing from the balance shaft.

1. Remove the balance shaft. Refer to Balance Shaft Replacement .
2. Using J 26941 and the J 38834 , remove the balance shaft rear bearing.

2.1.	Install the J 26941 legs behind the balance shaft rear bearing and secure.

2.2.	Install the J 38834-1 with the short threaded end through the balance shaft bore in the front of the engine block.

2.3.	Install J 38834-1 into the J 26941 .

2.4.	Slide the J 38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.

2.5.	Install the J 38834 bearing, washer, and nut onto the J 38834-1.

2.6.	Using a wrench, secure the J 38834-1, and then rotate the J 38834 nut clockwise until the balance shaft rear bearing is removed from the engine block.

2.7.	Remove the J 26941 from the balance shaft rear bearing.

3. Discard the balance shaft rear bearing.

1. Using J 38834 , install the balance shaft rear bearing.

1.1.	Install the J 38834-3 onto the short threaded end of the J 38834-1.

1.2.	Install the J 38834 nut, the washer, and the bearing on the long threaded end of the J 38834-1.

1.3.	Install the J 38834-2 onto the J 38834-1 so that the smaller diameter of the J 38834-2 will be facing the front of the engine block.

1.4.	Install the J 38834-2 on the inside of the balance shaft front bearing bore.

1.5.	Lubricate the NEW balance shaft rear bearing with clean engine oil.

1.6.	Install the balance shaft rear bearing onto the J 38834-2.

1.7.	Align the balance shaft rear bearing for installation.

1.8.	Using a wrench, secure the J 38834-1 into place.

1.9.	Rotate the J 38834 nut until the balance shaft rear bearing is properly and completely pushed into the balance shaft rear bearing bore.

2. Remove the J 38834 .
3. Install the balance shaft. Refer to Balance Shaft Replacement .