Special Tools

Important: 

•	Do not use the camshaft position (CMP) actuator solenoid valve again. Upon installation of the CMP actuator and timing chain, install a NEW valve.

•	Do not apply threadlock to the flex plate bolts at this time.

1. Temporarily install the automatic transmission flex plate and bolts. Refer to Automatic Transmission Flex Plate Installation.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the J 42386-A  (1) and bolts. Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.

Tighten
Tighten the J 42386-A bolts to 50 N·m (37 lb ft).




3. Remove the CMP actuator solenoid valve (234).
4. Discard the solenoid valve.

Caution: Refer to Camshaft Position Actuator Removal and Installation Caution in the Preface section.




5. Loosen and separate the CMP actuator and timing chain from the camshaft. Position fingers behind the actuator sprocket and pull the actuator away from the front of the camshaft. Never pull on the reluctor wheel when attempting to remove the actuator.



6. Remove the CMP actuator (235) and timing chain (208).



7. Insert a tie strap (1) through the center of the actuator and over the reluctor wheel.



8. Remove the bolts (231) and timing chain tensioner (232).



9. Use the J 41816-2  (1), the J 41558  (2), bolts (3), and the J 8433  (4) in order to remove the crankshaft sprocket.



10. Remove the crankshaft sprocket (207).



11. Remove the crankshaft sprocket key, as required.
12. Remove the flex plate and bolts. Refer to Automatic Transmission Flex Plate Removal.
13. Remove the J 42386-A and bolts.