Rear Seat Replacement 60/40 Split

1. Remove the front and the rear leg trim covers.
2. Remove the seat back recliner handle screw from the trim panel, if equipped.
3. Remove the jack assembly, if required.
4. Remove the covers in order to access the seat bolts.
5. Disconnect the electrical connectors, if equipped.
6. Remove the seat retaining bolts.



7. Remove the seat from the vehicle.

1. Install the seat into the vehicle.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the seat retaining bolts.

Tighten
Tighten the bolts to 55 N·m (41 lb ft).

3. Connect the electrical connectors, if equipped.
4. Install the jack assembly, if removed.
5. Install the covers to the seat bolts.
6. Install the seat back recliner handle screw, if removed.

Tighten
Tighten the screw to 2 N·m (18 lb in).

7. Install the front and the rear leg trim covers.

Rear Seat Replacement 50/50 Split 2nd Rear

1. Pull up on the handle at the rear of the seat.
2. Lift the seat up and out of the floor rails.
3. Remove the seat from the vehicle.

1. Install the seat into the vehicle.
2. Align the seat attaching points with the slots in the floor rail.
3. Roll the seat back and down in order to secure the seat into place.