Dome Lights May Not Come On or Buzz Noise When Turning on Dome Lamps (Rework Dome Lamp Wiring Harness and Reprogram BCM)

Some customers may comment that the interior dome lights may not come on. Other customers may also comment on a buzz noise when trying to turn on the dome lamps.

1. Locate and gain access to Fuse Block Body Connector X2 (62-Way Gray Connector) (8). Refer to Electrical Center Identification Views in SI.
2. Remove the Brown Wire (CKT 441) from pin 25.
3. Splice the Brown Wire (CKT 441) to the Blue/White Wire (CKT 149) found in pin 18 of the connector. Refer to Splicing Copper Wire Using Splice Sleeves in SI.
4. Remove the right front windshield garnish molding. Refer to Windshield Garnish Molding Replacement in SI.





5. Remove the Brown Wire (CKT 441) from in-line Front Headliner Harness to Body Harness Connector X205 (16-Way Black Connector) (2) in illustrations shown above from Cavity A and install into Cavity H.
6. Install the right front windshield garnish molding. Refer to Windshield Garnish Molding Replacement in SI.
7. Reprogram the BCM with the latest software available in TIS2WEB.
8. Verify that the condition has been corrected.

For vehicles repaired under warranty, use: