Tools Required
| • | J 43911 Selector Shaft Seal
Remover |
| • | J 43909 Selector Shaft Seal
Installer |
Removal Procedure:
- Remove the Park/Neutral Position (PNP) Switch. Refer to
Park/Neutral Position Switch Replacement
.
- Be sure that the jackscrew for J 43911
is backed off and will not interfere
with installation of the removal tool. Slide the seal remover tool over the
selector shaft (2) with the threaded end of the tool towards the seal.
- Rotate the removal tool so that the threads on the end of the
tool engage the steel shell (1) of the seal. Use a wrench to be sure that
the removal tool is firmly attached to the seal shell.
- Rotate the jackscrew in the clockwise direction to remove the
seal from the bore. Discard the seal that was removed.
Installation Procedure
- Carefully slide a new selector shaft
seal (1) over the selector shaft (2) with the wide face of the steel case
facing outward. Position the seal so that it is starting to enter the seal
bore.
- Obtain J 43909
and remove
the inner sleeve so that the tool will slide over the selector shaft.
- Slide the J 43909
into position
so that the end of the tool contacts the seal being installed. Use a mallet
to strike the J 43909
and drive the
new seal into the seal bore until it is seated at the bottom of the bore.
- Install the PNP Switch. Refer to
Park/Neutral Position Switch Replacement
.
