SMU - Revised Defroster Actuator Replacement Procedure

This bulletin is being issued to revise the Defroster Actuator Replacement procedure in the HVAC Systems with A/C - Manual sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

1. Remove the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages, and Console.



2. Disconnect the vacuum hose (1) from the defrost actuator (2).
3. Depress the clip and remove the defrost actuator (2) from the heater assembly.

1. Install the defrost actuator (2) to the heater assembly.
2. Connect the vacuum hose (1) to the defrost actuator (2).
3. Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages, and Console.