For 1990-2009 cars only
Special Tools
| • | J 6116-A Rear Gear Holding Fixture |
| • | J 6129 Handle |
| • | J 21364-A Rear Gear Holding Fixture Adapter |
| • | J 38868 Output Shaft Assembly Remover and Installer |
For equivalent regional tools, refer to Special Tools.
- Remove the center support bolt (25).
- Remove the rear fluid cooler pipe fitting (90), if equipped.
- Inspect the rear fluid cooler pipe fitting (90) for damaged threads.
- Inspect the rear fluid cooler pipe fitting seal (91) for nicks or cuts.
- Remove the center support retainer ring (633).
- Attach the J 38868 remover and installer to the transmission main shaft.
- Tighten the thumb screw on the J 38868 remover and installer .
- Install the J 6129 handle to the J 38868 remover and installer .
- Turn the J 6129 handle so that the handle shaft contacts the transmission main shaft.
- Remove the center support and gear unit assembly (640-672) by lifting the J 38868 remover and installer with the J 6129 handle .
- Remove the J 6129 handle and the J 38868 remover and installer .
- Place the center support and gear unit assembly (640-672) into the J 21364-A holding fixture adapter (not visible in the illustration) and then into the J 6116-A holding fixture .
Caution: Discard the center support bolt (25) after you have removed the bolt. Damage could result to the center support housing if you reuse the bolt.
