The MAP sensor is mounted to the PCV valve cover.

1. Turn OFF the ignition.
2. Remove the injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.
3. Disconnect the MAP sensor electrical connector.



4. Carefully bend the locking tabs holding the MAP (1) sensor to the PCV valve cover (2) just enough to remove the MAP sensor.
5. Pull the MAP sensor straight out of PCV valve cover.

1. Ensure that the seal is installed on the MAP sensor and that the seal is not damaged.
2. Position and install the MAP sensor (1) to the PCV valve cover (2). Ensure that the locking tabs engage to hold the MAP sensor to the PCV valve cover.
3. Connect the electrical connector.
4. Install the injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.