Tools Required
|     •  | J 42578  Steering
  Wheel Puller Legs | 
 
Removal Procedure
- Disable the SIR system. Refer to
Disabling the SIR System 
 in SIR.
 
- Position the ignition to the OFF position.
 
- Remove the inflatable restraint steering wheel module. Refer to
Inflatable Restraint Steering Wheel Module Replacement 
 in SIR.
 
- Scribe an alignment mark on the steering wheel hub. Align the
 mark with the slash mark on the steering shaft.
 
- Loosen the steering wheel nut.
 
- Position the nut flush with the end of the steering shaft.
 
- Assemble J 1859-A 
 with J 42578 
 on the steering wheel.
 
-  Using J 1859-A 
 with J 42578 
, remove
the   steering wheel from the steering shaft.
 
- Remove J 1859-A 
 with J 42578 
 from the
  steering wheel.
 
- Remove the steering shaft
 nut.
 
- Remove the steering wheel from the steering shaft.
 
- Disconnect the SIR connector from the steering wheel.
 
- Remove the steering wheel from the vehicle.
 
Installation Procedure
- Position the steering wheel on the steering column.
 
- Route the SIR connector
 through the steering wheel.
 
- Align the scribe mark on the steering wheel with the slash mark
 on the steering shaft.
 
- Install the steering wheel.
 
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the steering  shaft nut.
 
Tighten
Tighten the steering shaft nut to 45 N·m (33 lb ft).
- Install the inflatable restraint steering wheel module. Refer
 to 
Inflatable Restraint Steering Wheel Module Replacement 
 in SIR.
 
- Enable the SIR system. Refer to
Enabling the SIR System 
 in SIR.
 
- Inspect the operation of the following components:
 
| •  | The steering wheel controls |