Callout
| Component Name
|
|
Caution: Refer to Brake Dust Caution in the Preface section.
Caution: Refer to Brake Fluid Irritant Caution in the Preface section.
Preliminary Procedures
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
|
1
| Brake Hose Fitting Bolt
Notice: Refer to Fastener Notice in the Preface section.
Tighten
54 N·m (40 lb ft) |
2
| Brake Hose Fitting Gasket (Qty: 2)
Tip
DO NOT reuse the brake hose fitting gaskets. Install NEW gaskets. |
3
| Brake Hose
Tip
| • | Cap or plug the brake hose fitting to prevent brake fluid leakage and contamination. |
| • | Relocate the brake hose to the side . Secure the brake hose with the fitting facing UP at the highest point without damaging the brake hose. |
|
4
| Guide Pin Bolt (Qty: 2)
Tighten
36 N·m (40 lb ft) |
5
| Brake Caliper
Tip
- Bleed the hydraulic brake system. Refer to
Hydraulic Brake System Bleeding
.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 2-3 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
- Fill the master cylinder reservoir to the proper level. Refer to
Master Cylinder Reservoir Filling
.
- Burnish the pads and rotors. Refer to
Brake Pad and Rotor Burnishing
.
|
