Removal Procedure
- Apply the parking brake.
 
- Block the wheels.
 
- Drain all the reservoirs. Refer to 
Air Brake Reservoir Draining
 .
 
- Remove the air lines. Refer to 
Hose and Line Replacement - Nylon Push-In Type Fitting
 .
 
- Remove the reservoir support strap nuts.
 
- Remove the reservoir support straps from the reservoir supports.
 
- Remove the reservoir.
 
- Clean the air lines and the fittings with a dry cloth.
 
- Clean the inside reservoir with steam or hot water.
 
- Inspect the air lines for the following conditions: 
 
| •  | If any of these conditions are present, replace the air lines. | 
 
- Inspect the reservoir for corrosion or damage.
 
- Replace the reservoir if the reservoir is weakened.
 
- Inspect the reservoir supports and the straps for damage.
 
- Replace the supports and the straps, as needed.
 
Installation Procedure
- Install the reservoir.
 
- Install the reservoir support straps to the reservoir supports.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the reservoir support strap nuts.
 
Tighten
Tighten the rear axle service reservoir support strap tractor service nuts to 13 N·m (10 lb in).
- Install the air lines. Refer to 
Hose and Line Replacement - Nylon Push-In Type Fitting
 .
 
- Start the engine.
 
- Charge the system air pressure to the governor cut-out point.
 
- Stop the engine.
 
- Inspect for leaks with a soap solution. Leakage is not permissible.
 
- Inspect for proper brake operation.
 
- Remove the wheel blocks.